Sightline (C-value) calculator
A sightline C-value is how far, in millimetres, your line of sight to the touchline passes above the eyes of the person in front: 90 mm is the usual target and under 60 mm is poor. Set the rows, a target C and where the tier starts, and the calculator works out every row's riser, rake and achieved C, with steps capped at 35° exactly as Stadium Designer's editor does.
Sightlines in the starter grounds
Worst row and rake range for every stand, from the same engine the calculator uses.
| Ground | Stand | Rows | Worst C | Rake |
|---|---|---|---|---|
| Harbour Park | North Stand | 42 | 90 mm | 22–35° |
| Harbour Park | Quayside Stand | 26 | 90 mm | 22–29° |
| Harbour Park | Lighthouse End | 30 | 100 mm | 21–30° |
| Harbour Park | Dockers End | 34 | 90 mm | 20–33° |
| Elmfield Road | Main Stand | 30 | 90 mm | 22–34° |
| Elmfield Road | Popular Side | 18 | 90 mm | 22–28° |
| Elmfield Road | Railway End | 16 | 90 mm | 19–25° |
| Elmfield Road | Church End | 14 | 90 mm | 19–24° |
| The Kiln | Main | 28 | 86 mm | 27–35° |
| The Kiln | Furnace | 34 | 72 mm | 27–35° |
| The Kiln | Kiln End | 30 | 90 mm | 25–33° |
| The Kiln | Town End | 24 | 90 mm | 25–32° |
Rules of thumb for a design game, not engineering or safety advice.
Stands, roofs, corners, boxes and seat mosaics in 2D and 3D, then run a matchday or a concert and share the poster. Free, in your browser.
How it works
The point of focus is the near touchline at pitch level. Each spectator's eye is 1.15 m above their tread, rows are 0.8 m deep, and the front row of a lower tier sits 0.3 m above the pitch. Working back from the front row, each riser is set to give exactly the target C over the row in front:
N = (E + C) × D / D′ − E
- N: the riser, the step up from the row in front.
- E: eye height of the row in front above the touchline.
- D′, D: horizontal distances from the touchline to the eyes of the row in front and of this row (D = D′ + 0.8 m).
- C: the target C-value. No riser goes above 560 mm, the 35° limit.
Where the 35° cap bites, the row gets the maximum riser and its achieved C is worked out the other way round: C = (E + N) × D′ / D − E. Rows below 90 mm are flagged amber, below 60 mm red. To test an upper tier, set its start height and its distance from the touchline: the calculator uses the same row-by-row maths the editor applies to every tier, so the numbers agree with the stand inspector.
Frequently asked questions
What is a good C-value for a stadium?
90 mm is the usual target for seated spectators: enough to see the near touchline over the head in front. Between 60 and 90 mm you can see, but it's compromised; under 60 mm you're looking at the back of a head. Upper tiers in Stadium Designer's presets aim higher, at 110 mm.
How do you calculate the C-value?
C = (E + N) × D′ / D − E, where E is the eye height of the row in front above the point of focus, N is the riser between the two rows, D′ is the horizontal distance from the row in front to the point of focus and D the same for your row. Turned round, the riser a row needs is N = (E + C) × D / D′ − E.
Why are the back rows of a stand steeper than the front?
Each row has to clear the head in front by the same C, but the higher and further back you are, the more each step has to rise to do it. So the riser grows row by row, and a deep tier ends up much steeper at the back than at the front.
What is the maximum rake for stadium seating?
Stadium Designer caps every step at 35°: with 0.8 m rows that's a riser of 560 mm. Once a row needs more than that to reach the target, the cap holds and its C-value falls short, which the calculator flags.
How does the distance from the pitch affect sightlines?
The closer the front row, the steeper the tier must be to keep the same C. The Kiln keeps its stands tight to the pitch: its 34-row Furnace stand hits the 35° cap and bottoms out at a C-value of 72 mm.
Rules of thumb for a design game, not engineering or safety advice. The calculators use Stadium Designer's simplified model; real grounds are designed by qualified engineers to the Guide to Safety at Sports Grounds and local licensing conditions.